Replacing a fuse

Citroen C4 / Citroen C4 Owner's Manual / Practical  advice / Replacing a fuse

Fuse box

There are two fuse boxes, one below the dashboard and one under the bonnet.

Fuses under the dashboard

To access the fuses below the dashboard, pull back the access cover, undo the screws a quarter turn and tilt the whole unit.

Replacing a fuse

Before replacing a fuse, it is essential to find the cause of the incident and to rectify it. The fuse identification numbers are indicated inside the fuse box.

Replace a blown fuse with one of the same rating (the same colour)

Use the special pliers A stowed on the cover close to the fuseboxes, this includes a compartment for replacement fuses.

Good

Faulty

Faulty

Tool A

Tool A

Access to the first fusebox under the dashboard

Access to the first fusebox under the dashboard

Fuses under the dashboard

Fuses under the dashboard

Your vehicle’s electrical system is designed to operate with standard or optional equipment. Before installing other electrical equipment or accessories in your vehicle, contact a CITROËN dealer. CITROËN will not accept responsability for the cost incurred in repairing your vehicle or for rectifying the malfunctions resulting from the installation of accessories not supplied and not recommended by CITROËN and not installed in accordance with its instructions, in particular when the consumption of all of the additional equipment connected exceeds 10 milliamperes.

    See also:

    Rear lamps
    1. Brake/sidelamps (P21/5W). 2. Direction indicators ( PY21W amber) 3. Foglamp, left-hand side ( PR21W red) Reversing lamp right-hand side (P21W). Amber or red bulbs, such as those for the d ...

    Manual controls
    The wiper commands are issued directly by the driver by means of the stalk A and the ring B . Windscreen wipers A. wiping speed selection stalk: fast (heavy rain), normal (moderate rain), in ...

    Electric parking brake
    The electronic parking brake combines 2 operational modes: AUTOMATIC: Automatic application when the engine is stopped and automatic release on use of the accelerator (automatic operation by def ...

    // -->