Locking the doors from the inside
With the doors closed, press button B once to operate the electric central locking and unlocking.
The doors can still be opened from inside.
The central locking will not operate if a door is open, or not properly closed.
The lamp on the control B can signal any of 3 statuses:
- It flashes if the doors are open when the vehicle is stationary, engine stopped.
- It lights up if the doors are locked and the ignition is switched on.
- It goes out if the doors are not locked.
Note: Control B is inactive if the vehicle has been locked with the remote control or with the key.
When the vehicle is started, the system automatically locks the doors and tailgate as soon as you reach a speed of approx. 10 km/h (6 mph).
Note: If a door is opened, this door will automatically relock as soon as the vehicle reaches approx. 6 mph.
Activation/Deactivation of the function
After switching on the ignition, give a long press on the central unlocking button until a message is displayed.
If you decide to drive with the doors locked, remember that in the event of an accident this renders access more difficult for the emergency services.
Manual operation (emergency mode)
In the event of an electrical fault, it is possible to lock the vehicle’s doors by actioning control C on each door. With the door open, insert the end of a key or similar item into the aperture and turn.
Close the door.
After a repair, normal functioning resumes using either the unlocking control B, the remote control, or the key used in the driver’s door.
4. Head restraint height adjustment. ...
Fitting the wheel
After changing a wheel To store the punctured wheel in the boot correctly, fi rst remove the central cover. When using the "space-saver" type temporary use spare wheel, do not exceed ...
Running out of fuel (diesel)
If your vehicle is fi tted with an HDI engine, the fuel circuit must be reprimed if you run out of fuel. This system consists of a repriming pump, a transparent pipe and a degas screw under the b ...