Front seat belts
The front seat belts are fi tted with a pretensioning and force limiting system.
This system improves safety in the front seats in the event of a front impact.
Depending on the severity of the impact, the pretensioning system instantly tightens the seat belts against the body of the occupants.
The pretensioning seat belts are active when the ignition is on.
The force limiter reduces the pressure of the seat belt on the chest of the occupant, so increasing their protection.
- Pull the strap, then insert the tongue in the buckle.
- Check that the seat belt is fastened correctly by pulling the strap.
- Press the red button on the buckle.
- Guide the seat belt as it is reeled in.
Seat belt not fastened/ unfastened warning lamp
When the ignition is switched on, this warning lamp comes on in the instrument panel, if the driver and/or the front passenger has not fastened their seat belt.
From approximately 12 mph (20 km/h) this warning lamp fl ashes for two minutes accompanied by an audible signal of increasing volume. Once these two minutes have elapsed, this warning lamp remains on until the driver and/or the front passenger fastens their seat belt.
Manual guide-me-home lighting
Temporarily keeping the dipped headlamps on after the vehicle's ignition has been switched off makes the driver's exit easier when the light is poor. Switching on With the ignition off, &quo ...
Exterior perimiter protection
The system detects opening of the vehicle. The alarm is triggered if anyone tries to enter the vehicle by forcing a door, the boot or the bonnet. ...
The dual-zone system regulates the temperature and air distribution for the drivers's side and the passenger's side independently. The air flow is common to both sides. 1a Driver's side ...